4/3/2023 0 Comments Which opensprinkler systemSelect yes and then hold B3, a hardware reset will be triggered, and the controller will recover to default settings.įrom OpenSprinkler 2.1, holding B2 while starting the controller will enter bootloader mode, which allows you to flash the microcontroller with a new firmware. Reset: on OpenSprinkler 2.0 and prior versions, holding B2 while starting the controller provides a short-cut to the Reset option. The self-test time can be changed in options. This is useful for quickly checking if all stations are working. The self-test mode opens each station for 10 seconds in turn, including stations on the zone expansion boards (if you have). Self-test: this is activated by holding B1 while starting the controller. Once you are done, hold B3 again, until the controller restarts.Note that some options can only be set via the web interface and cannot be changed using buttons. Click B3 to cycle through all available options, and click B1 or B2 to increase or decrease the value of each option.Hold pushbutton B3 while starting the controller, until you see the message Setup Options. However, if you wish, you can change the controller options /settings by following the procedure below: The controller is programmed with a list of options. If you are not sure, ask a landscaper or go to a home improvement store to ask for help. For multiple valves: one wire from each valve is combined together and goes to the COM terminal, and the other wire of each valve goes to its corresponding station terminal. Connect one wire to the COM (Common) terminal (either of the two ports), and the other wire to an individual station terminal (S1-S8). The LCD should turn on and start displaying messages.Ī sprinkler valve has two wires. This can help prevent mistakes in plugging in power.Īfter connecting the power supply, slide down the power switch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |